HOW TO CONFIGURE CISCO ROUTER
Make coonection from pc to router using console cable
Connect using putty or hyperterminal
>>setup ip and force to up for interface fa0/0
Command
Router#configure
terminal
Enter
configuration commands, one per line.
End with CNTL/Z.
Router(config)#interface
fa0/0 *
Router(config-if)#ip
address 172.16.1.1 255.255.255.0
Router(config-if)#no
shutdown
Router(config-if)#exit
Router(config)#exit
Router#copy
run start
Destination
filename [startup-config]?
Building configuration...
[OK]
·
*insert yourinterface port ether fa0/1, s0/1,
s0/0
Do routing protocols for router
What is Routing Protocols?
A routing protocol specifies how routers communicate with each
other, disseminating information that enables them to select routes between any
two nodes on a computer
network. Routing algorithms determine the
specific choice of route. Each router has a priori knowledge only of networks attached
to it directly. A routing protocol shares this information first among
immediate neighbors, and then throughout the network. This way, routers gain
knowledge of the topology of the network.
Routing Protocols : OSPF, EIGRP, RIP
Command:
Router>ena
Router#config
t
Enter
configuration commands, one per line.
End with CNTL/Z.
Router(config)#router
eigrp* 1
Router(config-router)#network
172.16.0.0
Router(config-router)#network
172.10.0.0
Router(config-router)#network
192.168.3.0
Router(config-router)#no
auto-summary
Router#copy
run start
Destination
filename [startup-config]?
Building
configuration...
[OK]
·
*ospf/rip
*TO BE CONTINUE ACL
